Problems with Matrox Millenium G450 dual head graphics card
Posted: Tue Dec 07, 2004 11:36 am
I'm sure this is something you will have come across (and certainly hope so).
I have just installed a Matrox Millenium G450 dual head 32MB AGP graphics card on a Windows 2000 pc. The pc has just had a fresh install of windows, the graphics card drivers were loaded from the original Matrox CD and of course Zionworx was loaded in the normal manner.
However, whilst I can get both monitors to work when viewing my windows desktop (either splitting the desktop in two or simply showing the same on both screens), I cannot figure out how to make the Zionworx Presentation Screen to show.
When viewing "display properties" under control panel, I had expected to see two monitors but only see one. I am unsure whether this is relevant or simply a red herring to confuse matters.
Whilst I am sure this is simply a set-up issue on my part, I am now getting to the "banging my head against the wall" stage so any and all advice shall be gratefully received.
Thanks in anticipation.
Bryan.
I have just installed a Matrox Millenium G450 dual head 32MB AGP graphics card on a Windows 2000 pc. The pc has just had a fresh install of windows, the graphics card drivers were loaded from the original Matrox CD and of course Zionworx was loaded in the normal manner.
However, whilst I can get both monitors to work when viewing my windows desktop (either splitting the desktop in two or simply showing the same on both screens), I cannot figure out how to make the Zionworx Presentation Screen to show.
When viewing "display properties" under control panel, I had expected to see two monitors but only see one. I am unsure whether this is relevant or simply a red herring to confuse matters.
Whilst I am sure this is simply a set-up issue on my part, I am now getting to the "banging my head against the wall" stage so any and all advice shall be gratefully received.
Thanks in anticipation.
Bryan.